This presser foot is used for sewing on strands of pearls, beads or sequins.
Braiding to a width of up to 4 mm as well as transparent or decorative threads can be sewn on. The strand can also be sewn in the middle of fabric by sewing along a folded edge with flatlock.
Series & Part Number
MO-2800: 40138106
MO-1000: 40138106
MO-735: A9870-634-0A0A
MO-114D/104D: A9870-634-0A0A
MO-655: A9870-634-0A0A
MO654DE/MO-644: A9870-634-0A0A
MO-623: A9870-634-0A0A
MO-50e: 40131949
MO-80CB: 40131949
MO-1200QVP: A9870-634-0A0A
MO-2000QVP: 40138106
This guide is used for sewing parallel rows of stitching that are equally spaced.
This guide, installed on either side of the needle, can be used for stitching on either the left or the right side.
With marks on the guide bar at a 1/5" (5 mm) spacing, this guide can be moved as far as 2.32" (60 mm) to the left or right side of the needle.
This presser foot is used for sewing on piping while overlocking the edge of the fabric.
Sew along the edge of the piping with the tubular part of the tape fed into the groove along the bottom of this presser foot. Use either both needles or only the left needle with this presser foot.
Series & Part Number
MO-2800: 40138103
MO-1000: 40138103
MO-735: A9865-655-0A0A
MO-114D/104D: A9865-655-0A0A
MO-655: A9865-655-0A0A
MO654DE/MO-644: A9865-655-0A0A
MO-623: A9865-655-0A0A
MO-50e: 40131950
MO-80CB: 40131950
MO-1200QVP: A9865-655-0A0A
MO-2000QVP: 40138103
This box collects scraps of fabric cut by the overlock sewing machine.
This is useful for throwing out all scraps after work is completed, without allowing them to scatter around the work area. When storing the sewing machine, accessories such as the foot controller can be stored in the box.
Series & Part Number
MO-1000/2000: 40134096
MO-735: A9108-130-000
MO-114D/104D: A910-880-L000
MO-655: A9108-202-000
MO-654DE: A9108-202-000
MO-644D: A9108-202-000
MO-623: A9108-202-000
MO-1200QVP: A910-880-L000
This presser foot is used for sewing on strands of pearls, beads or sequins along curves.
Braiding of a width of up to 4 mm can be sewn onto an outside curve (towards the left) with a diameter of at least 15 cm. This presser foot being short at the front allows it to easily follow curves